This is a small DC voltage and current sense board used to measure and feed votage and current info via Mavlink to Mission Planner or the SteadiDropne AGC, this will allow you to monitor voltage and current live whil in the air!

How to setup HERE
Select AttoPilot 50V 90A in APM setup panel in Mission Planner.

Hardware Features:
   • 51.8V Max
   • 89.4A Max
   • Very low zero current offset
   • Analog output scaled for 3.3V ADC
   • Self Powered

Other
 •Dimension: 15x17mm

Package content
 •V & I Sensor x 1
 •UART 3Pin cable 150mm x1
 •12AWG leads 50mm x4
 •XT60 male & female connector x1
 •Deans male & female connector x1